材料与试验协会 B111M-98ｅ2铜和铜合金无缝冷凝器管和套圈坯料（米制）.PDFVIP

Designation: B 111M – 98 (Reapproved 2004) METRIC Standard Specification for Copper and Copper-Alloy Seamless Condenser Tubes and Ferrule Stock [Metric]1 This standard is issued under the fixed designation B 111M; the number immediately following the designation indicates the year of original adoption or, in the case of revision, the year of last revision. A number in parentheses indicates the year of last reapproval. A superscript epsilon () indicates an editorial change since the last revision or reapproval. This standard has been approved for use by agencies of the Department of Defense. 1. Scope* A Designations listed in Classification B 224. 2 covers seamless tube and ferrule NOTE 1—This specification is the metric companion to Specification B 1.1 This specification stock of copper and various copper alloys up to 79 mm, 111. inclusive, in diameter, for use in surface condensers, evapora- NOTE 2— Warning—Mercury is a definite health hazard in use and disposal. (See 12.1.) tors, and heat exchangers. Tubes for this application are normally made from the following coppers or copper alloys:3 1.2 The following safety hazards caveat pertains only to the Copper or test methods portion, Section 18, of this specification: This Copper Previously Used standard does not purport to address all of the safety conc