骨科手术钢板 .PPTVIP

用于股骨远端外侧骨折 骨板分左右 规格： 4.5mm system: 6~18 holes Knee Joint 膝关节 Distal Lateral Femoral Plate 股骨远端外侧钢板 Distal Lateral Femoral Plate 股骨远端外侧钢板 Distal Lateral Femoral Plate 股骨远端外侧钢板 用于股骨远端内侧骨折 骨板分左右 规格： 4.5mm system: 2~8 holes Knee Joint 膝关节 Distal Medial Femoral Plate 股骨远端内侧钢板 用于胫骨近端外侧骨折 骨板分左右 规格： 4.5mm system: 2~14 holes 3.5mm system: 4~16 holes Knee Joint 膝关节 Proximal Lateral Tibial Plate 胫骨近端外侧钢板 Proximal Lateral Tibial Plate 胫骨近端外侧钢板 4.5mm Proximal Lateral Tibial Plate 胫骨近端外侧钢板 Confidence in your hands * Confidence in your hands Confidence in your hands * Confidence in your hands * Confidence in your hands * Confidence in your hands * Confidence in your hands * Confidence in your hands * Confidence in your hands * Confidence in your hands * Confidence in your hands * Confidence in your hands * Confidence in your hands * Confidence in your hands * Step 3 You may not have to go through this process; however, it may help build up Zimmer’s overall reputation and commitment to trauma. Show the doctor the picture of the computer model inside the first page of the brochure. Point out that we starting with the bone rather than the implant. We recognized that we needed to first understand where we wanted to put the implant. This was actually facilitated by having the developing surgeons draw on a sawbone where they would like a plate to go if they could have one that would actually fit. Using the computer data on the bones we were able to use an “electronic cookie cutter’ to acquire the exact shape we were looking for. This data was then used to make a prototype right off of the bone scans. Rather than start with a piece of metal and trying to bend it to fit; we started with a bone and made an implant that would fit. We tried different shaped until we found the shape that fit the most bones the best. The plates will not fit everyone perfectly; however, they are so much better than anything else available it is incredible. These are high tech plates t