操纵车把灯车推至平坦位置.doc

Light Tower Generator- Light Tower Generator-Technical Data Sheet Ⅰ. Component List No Part Name Q’ ty Remarks 1 RPD6500i（Diesel Generator Set） 1 2 Tower Assembly. w/Pillar 1 3 Wheel Mounted 2 4 Ring Hitch 1 5 Fixture(Light) 4 6 Outrigger 4 7 Fuel Tank Cap 1 8 Light Cross Arm 1 9 Tongue 1 10 Tower Support Cradle 1 11 Hand Tool Box 1 12 Manual 1 Ⅱ. Part No Description Product Size(mm) N.W.(KG) Packing Size(mm) Q’ty /Packing Case G.W.(KG) 1 Generator 1pc/ Packing Case 2 Mast 1pc/ Packing Case 3 Light 1pc/ Packing Case Ⅲ. Packing Ⅳ.Instructions for Installation 3. Let down Jack Prop 3. Let down Jack Prop 3. 逆时针方向旋转撑脚千斤顶手柄, 升起四个撑脚, 使车身保持平衡,如图3; Turn the Jack handles anticlockwise to let down the jack prop， keep the light car in balance。 千斤顶：Jack lift 撑脚: Prop 2. Brake the light car Align two wheels with wheel hub, thread 5 screws out from the holes and fix them with nuts solidly (as shown in Figure B-1) 2. 踩下刹车踏板锁住后轮, 防止灯车滑动, 如图2; Step on the brake to lock the back wheels to avoid sliding of light car。 刹车踏板：BRAKE 1. Handle the light car 1. 操纵车把灯车推至平坦位置, 车把左移前轮右拐, 车把右移前轮左拐, 如图1; Get the light car to flat ground, turn the handle left to move front wheels right, turn the light handle right to move front wheels left. 车把： Handle 前轮： Front Wheel 5. 将固定灯架 5. 将固定灯架的螺帽旋松, 可90度旋转灯架, 调整好灯架水平方向角度, 然后旋紧, 如图5; Loose the screws of light fixture, the light fixture can be rotated in 90 degree, adjust horizontal angle of the fixture to a standard level then fix the screws solidly. 6. 将灯横杆下方的锁紧螺栓旋松, 可360度旋转灯横杆, 调整好四个灯水平方向的角度, 然后旋紧, 如图6; Loose the screw bolt below the light cross arm to turn the arm in 360 degree, adjust the the horizontal angles of 4 lights to a standard level, then fix the screws solidly. 灯横杆：light Cross Arm 锁紧螺栓：Screw bolt 4. Mount Front Wheel 4. 将固定灯罩的螺帽旋松, 可260度旋转灯罩,调整好灯罩垂直方向角度, 然后旋紧,如图4; Loose the screws of lampshade, the lampshade can be rotated in 260 degree, adjust the lampshadle to vertical angle then fix the screws solidly. 5，前轮安装： （2）将前转向轮对准千斤顶下方孔插入，将个固定