小区7层住宅楼低压配电专业系统设计.docVIP

分类号：TU976+.1 U D C：D10621-408-( ) 1446-0 密 级：公 开 编 号： 07 分类号：TU976+.1 U D C：D10621-408-( )1446-0 密 级：公 开 编 号： 07 成全部信息工程学院 学位论文 某小区7层住宅楼低压配电系统设计 论文作者姓名： 申请学位专业： 电气工程及其自动化 申请学位类别： 工学学士 指导老师姓名（职称）： 论文提交日期： 06月10日 某小区7层住宅低压配电系统设计 摘 要 这次毕业课程设计题目是对某小区7层住宅低压配电系统设计，不考虑电梯设计，每层有4户住户，每栋楼有三个单元，不考虑地下层设计，不考虑屋顶装饰照明设计。这次毕业课程设计关键是对于住宅弱电系统来进行考虑和设计，设计关键内容分为四点：1.依据相关要求和条例对负荷等级划分来确定此次设计供电方法和整个系统计划方案；2.先把设计负荷计算出来，然后依据计算负荷结果来选择出对应导线截面积和型号，还有穿线保护管型号，断路器型号，和相关电线电缆选型；3.选择照明灯具，插座系统选择，和其对应安装高度还有导线敷设方法；4.对住宅安全中防雷和接地安全方面设计，最终得出此次设计结果和结论。相关这次课程设计，我们关键是偏重于所学电气相关基础知识和基础电气理论。此次设计还需按摄影关民用建筑设计规范来计划整体设计思绪，最终完成对负荷计算，照度计算，设备选型，和绘制相关作业图，小区住宅配电设计方案。 关键词：低压配电系统；负荷计算；、照度；防雷接地设计；设备选择 The Design of Residential 7-story Residential Low-voltage Distribution System Abstract The topic of this graduation design is of a District 7 story residential low-voltage distribution system design, does not consider the elevator design, each layer 4 households, each floor has three units, without considering the underground layer design, regardless of the roof decorative lighting design.?This graduation design course is mainly for residential electricity system to consider and design, the main content of the design is divided into four points: 1. according to the relevant rules and regulations on the load grade to determine the planning scheme of the design of the power supply and the whole system; 2. first calculated the design load, and then according to the calculation results of load to select the corresponding sectional area of wire and type, and wear line protection tube type, circuit breaker type, and the selection of wire and cable related; 3. choice of lighting, socket system selection, and the corresponding installation height and wire laying method; 4. the lightning protection residential security and grounding safety aspects of the design, finally the design results and conclusions.?Regarding this curriculum design, we are mainly focused on the basic knowledge and basic elec