断血流中药前处理车间工艺设计.pdfVIP

目录 摘要 本设计为年产 500 万袋（ 10g/袋）的断血流颗粒提取液前处理 工段工艺流程设计，本设计所采用的工艺路线为 ：取断血流，切段， 加水煎煮二次，每次 1.5 小时，合并煎液，滤过，滤液浓缩至为 1.15 （85℃）的清膏，加入乙醇使含醇量为 60%，搅匀，静置 24 小时，取 上清液回收乙醇并浓缩至相对密度为 1.25 （80℃ ）的稠膏。取清膏 蔗糖粉、糊精及适量，混匀，制成颗粒，干燥即得。设计全内容包 括进行流程设计，车间工艺设计，物料衡算，热量衡算（略）及工艺 设备选型计算，车间布置设计，部分工段的配管设计 （略），物料流 程 图，带控制点工艺流程 图，平面布置 图，编写设计说明书。本设 计根据任务书的要求，通过工艺计算，对工艺流程，设备选型、车 间总布局进行合理设计，同时根据主要 设备确定能耗及物耗，并 对生产管理、三废治理等进行设计。 关键词 ：断血流颗粒 工艺流程设计 设备选型 物料流程图 I Abstract This preliminary design is for a Duanxueliu Keli isolated liquidworkshop whose annual product is 50 tons. Take off the blood flow, cut into sections, add boiling water twice, each 1.5 hours, combined decoction, filtration, the filtrate was concentrated to the relative density of 1.15 (85 ℃) of clear paste, add the amount of ethanol to 60% with alcohol , stir well and let stand 24 hours, the supernatant was concentrated to recover ethanol and the relative density of 1.25 (80 ℃) of thick cream. Extract the cream sugar powder, dextrin and the amount of stevia elements, mixing, made of particles, drying derived. According to the assignment,through technical calculation, reasonable design about technical process,equipment,workshop’s location is required. And then based on the main equipments , consume of energy and material should be decided. In this process raw material and product are circulated. Technological route is advanced. Cost of production is low Quality of produce is high . [Keyword] Duanxueliu Keli radix glycyrrhizae professional design II ;