2T-50多模面水平环模成型机设计.doc

PAGE 8 2T-50多模面水平环模成型机设计 摘 要 能源和环境问题已成为全球关注的焦点。随着能源消耗的迅速增长，传统化石燃的逐渐枯竭和严重的环境污染等问题。生物质能作为一种可再生能源，它具有可再生，无公害，污染小等优点，是传统化石能源的最佳替代品。对于我国现状，1.农作物秸秆资源非常丰富，但大部分没有得到合理有效的利用。2。经济的迅速发展导致矿物质急速枯竭与环境污染严重。生物质能源转换技术在使秸秆资源得到充分利用的同时，也增加了农民的收入，也为促进农业的可持续发展做出贡献。 本成型机包括四面料壁，机架，电机，减速器，立轴，压轮，环型模具。与以往的成型机不同的是电机和减速器在环模上端环型模具与地面30-40厘米。 本论文是通过市场上的环模成型机出现的各种问题进行理论分析和通过前辈们的试验工艺参数优化的理论为基础，并在此基础上做出改进设计。能耗低，产量高，寿命长，成型燃料密度高，运输方便，不用附带进料设备，室外、山田、都能工作的生物质燃料成型机。 关键词： 生物质；水平成型机；环模 2T-50 multi-mode surface level ring molding machine design Abstract Energy and environmental issues have become the focus of global attention. With the rapid growth of energy consumption, the gradual depletion of conventional fossil fuel and serious environmental pollution problems. Biomass as a renewable energy source, it has the advantages of renewable, pollution-free, pollution is the best alternatives for traditional fossil energy. The situation of our country, a crop straw resources are very rich, but most did not get a reasonable and efficient use.Two. Rapid economic development has led to rapid depletion of minerals and serious environmental pollution. Biomass energy conversion technology in the straw resources are fully utilized, but also increase farmers income, and also to contribute to the promotion of sustainable agricultural development. This molding machine including four fabric wall, rack, motor, reducer, vertical, roller, ring mold. Different to the previous molding machine is the motor and gear ring mold in the upper end of the ring die and 30-40 cm above the ground. This paper is the ring molding machine on the market a variety of issues of theoretical analysis and by predecessors test optimization of process parameters based on the theory, design and make improvements on this basis. Low energy consumption, high output, long life, high density of the briquette, transportation