塑料加工设备及模具.ppt

R * ppt课件 注拉吹成型 (ISBM) Fig.10.28 * ppt课件 R * ppt课件 R * ppt课件 * Jan-03, * Jan-03, * Jan-03, * Jan-03, This would be an unoriented material * Jan-03, * Jan-03, While most people refer to MD and CD, some plastic people call it TD (transverse direction) * Oct.02, * Jan-03, This is a cut-away of a three layer coextrusion die.The point where the three layers come together can be clearly seen. * Jan-03, Bubble diameters an be 9 feet and more. The larger the bubble the higher the collapsing frame. Large bubbles require a 4-story building. * Jan-03, August 04, This is high density polyethylene being blown into a bubble. The freeze line where the PE crystallizes and becomes translucent clarity can be clearly seen. * Dec-02, * Dec-02, An injection molding machine is rated by its available clamping tonnage. A 200 ton machine is able to exert 200 tons of force to hold a mold closed during the injection cycle. * Dec-02, * Jan-03, November 04, Note that the distance from the sprue to each mold cavity is exactly the same. The deodorant case is very thick plastic and is double gated. * Dec-02, Sink marks are found most readily on the skirt of a large threaded closure and on some flip-top closures opposite the sealing pin and interior support ribs. I carry a handful of closures as visual aids. * Feb.02, Dec-02, Undercuts require molds with mold parts that must be moved before the part can be extracted. This increases mold cost significantly. * Dec-02, * Feb-03, The mold body is aluminum, the inserts (1 3) are tool steel. The cut-off insert wears and can be sharpened and or replaced. The neck-ring can be changed to accommodate different finishes on the same bottle form. * Dec-02, Most current EBM processes will mold two, three and sometimes four bottles at a time. * Dec-02, Jan-04, Mar-04, * Dec-02, The trim parts are normally reground and returned to the extruder. (This is not allowed for some pharmaceutical containers). The pinch-off trim is also known a