WorleyParsons 沃利帕森斯设计指南 KS-PR-DEG-0120 Control Valve Design Guide.pdf

Control Valve Design Guide Document No: KS-PR-DEG-0120 Rev 0 01 December 2019 © Copyright 2019 Worley ACN 096 090 158. No part of this document or the information it contains may be reproduced or transmitted in any form or by any means electronic or mechanical, including photocopying, recording, or by any information storage and retrieval system, withou t permission in writing from Worley. Table of Contents 1. Introduction 4 2. Scope 4 3. Flow Conditions – Terms and Definitions 4 3.1 General 4 3.2 Evaluating the appropriate operating cases and flow rates 4 3.3 Customer and or Project control valve pressure drop requirements 6 4. Design Criteria – Terms and Definitions 7 5. Phasing of Control Valve Pressure Drop Calculations 8 5.1 Conceptual design study 8 5.2 Basic design and engineering project 8 5.3 Detailed engineering project 9 6. Control Valve Pressure Drop Versus System Flow 9 6.1 General 9 6.2 Control valve pressure drop versus flow - pressure motivated system 10 6.3 Control valve pressure drop versus flow – system centrifugal pump 10 6.4 Valve pressure drop versus flow for Pressure motivated system and Centrifugal pump system Control Valve Design Guide ii KS-PR-DEG-0120 Rev 0 01 December 2019 11 7. Control Valve Inherent Characteristics 11 8. Control Valve Authority and Installed Characteristics 12 8.1 General 12 8.2 Control valve Authority 12 8.3 Installed control valve characteristic 12 9. Determination of The Circuit 13 10. Control Valve Minimum Pressure Drop Requirements 17 10.1 General 17 10.2 Flow conditions to be used 17 10.3