WorleyParsons 沃利帕森斯设计指南 KS-PR-DEG-0198 Critical Orifice Design Guide.pdf

Critical Orifice Design Guide Document No: KS-PR-DEG-0198 Rev 0 01 December 2019 © Copyright 2019 Worley ACN 096 090 158. No part of this document or the information it contains may be reproduced or transmitted in any form or by any means electronic or mechanical, including photocopying, recording, or by any information storage and retrieval system, without permission in writing from Worley. Table of Contents 1. Purpose and Scope 3 2. Roles and Responsibilities 3 3. Actions and Requirements3 3.1 Terminology 3 3.2 Background 3 3.3 Critical Pressure Ratio 5 3.4 Critical Flow Equation 5 3.5 Coefficient of Discharge 6 3.5.1 Thin plates 6 3.5.2 Thick plate 6 3.6 Documentation 7 4. Definitions7 5. References 7 Appendices No table of contents entries found. Critical Orifice Design Guide ii KS-PR-DEG-0198 Rev 0 01 December 2019 1. Purpose and Scope The purpose of this document is to provide a standard guideline for the Process Department work on critical flow orifice design. Adherence to this Practice is important for design, checking and overall quality assurance. This procedure is for design of high pressure drop orifices in vapor service. It does not apply to liquid service, or to vapor service where the pressure ratio across the orifice is less than the critical pressure ratio. 2. Roles and Responsibilities The process engineer shall follow this procedure when designing critical flow orifices. 3. Actions and Requirements 3.1 Terminology The common term used for high differential orifice plates used to limit flow to a defined maximum is “Restriction Orifice” since they are used t