WorleyParsons 沃利帕森斯设计指南 KS-PR-DEG-0194 Steady State Heat Loss of Storage Tank Design Guide.pdf

Steady State Heat Loss of Storage Tank Design Guide Document No: KS-PR-DEG-0194 Rev 0 01 December 2019 © Copyright 2019 Worley ACN 096 090 158. No part of this document or the information it contains may be reproduced or transmitted in any form or by any means electronic or mechanical, including photocopying, recording, or by any information storage and retrieval system, without permission in writing from Worley. Table of Contents 1. Introduction 3 2. Scope 3 3. Overview of Design Guide 3 4. Environmental Heat Transfer Coefficient 4 4.1 Air Side Convection Heat Transfer 5 4.2 Air Side Radiant Heat Transfer 5 5. Heat Transfer Through Tank Wall, Roof and Floor7 5.1 Dry Wall Heat Loss Calculation 7 5.2 Wet Wall Heat Loss Calculation 8 5.3 Roof Heat Loss Calculation9 5.4 Floor Heat Loss Calculation9 6. Overall Evaluation of Heat Loss 9 7. Definitions 13 8. References 16 Steady State Heat Loss of Storage Tank Design Guide ii KS-PR-DEG-0194 Rev 0 01 December 2019 1. Introduction This Design Guide is to be used in conjunction with Equipment Heat Loss Calculation KS-PR-CAL-0006. This Process Design Guide is intended for use as a tool in the organization of Process Engineering. It is not normally issued on a project, however documents based on it, such as process datasheets, may be issued. 2. Scope The purpose of this Design Guide is to provide guidance for evaluation of steady state heat loss from a storage tank. It is intended to provide the user with a best practice view, but it is the duty of the user to make all efforts to confirm the content meets (or exceeds) the global industry standard, local regulations, and customer requirements. Calculation theory and basic criteria is outlined