WorleyParsons 沃利帕森斯设计指南 KS-PR-DEG-0193 Steady State Heat Loss of Flowing Fluid in Lines Design Guide.pdf

Steady State Heat Loss of Flowing Fluid in Lines Design Guide Document No: KS-PR-DEG-0193 Rev 0 01 December 2019 © Copyright 2019 Worley ACN 096 090 158. No part of this document or the information it contains may be reproduced or transmitted in any form or by any means electronic or mechanical, including photocopying, recording, or by any information storage and retrieval system, without permission in writing from Worley. Table of Contents 1. Introduction 3 2. Scope 3 3. Overview of Design Guide 3 4. Calculation Theory 4 4.1 Insulation Considerations 4 4.2 Inside Film Coefficient5 4.3 Air Side Convection Heat Transfer 6 4.4 Air Side Radiant Heat Transfer 7 4.5 Buried Line Heat Loss Model 9 5. Overall Evaluation of Heat Loss 9 5.1 Flow Line in Atmosphere 9 5.2 Buried Flow Lines 12 6. Definitions 12 7. References 14 Appendices Appendix A. Thermal conductivity for specific soil Steady State Heat Loss of Flowing Fluid in Lines Design Guide ii KS-PR-DEG-0193 Rev 0 01 December 2019 1. Introduction This Design Guide is to be used in conjunction with Pipe Heat Loss Calculation KS-PR-CAL-0007. Other heat loss tools or software may apply slight variations on the theory or calculation approach. This Process Design Guide is intended for use as a tool in the organization of Process Engineering. It is not normally issued on a project, however documents based on it, such as process calculation records or datasheets, may be issued. 2. Scope The purpose of this Design Guide is to provide guidance for evaluation of steady state heat loss from flowing fluid lines. It is intended to provide the user with a best practice view, but it is the duty of the user to make all efforts to confirm the co