WorleyParsons 沃利帕森斯设计指南 KS-PR-DEG-0157 Fuel Gas System Design Guide.pdf

Fuel Gas System Design Guide Document No: KS-PR-DEG-0157 Rev 0 01 December 2019 © Copyright 2019 Worley ACN 096 090 158. No part of this document or the information it contains may be reproduced or transmitted in any form or by any means electronic or mechanical, including photocopying, recording, or by any information storage and retrieval system, without permission in writing from Worley. Table of Contents 1. Introduction 3 1.1 Scope 3 2. System Description3 2.1 Introduction 3 2.2 Fuel Gas Specification 3 2.3 Fuel Gas Source 5 2.4 Fuel Gas Conditioning 5 2.5 Fuel Gas Distribution6 2.6 Contingencies6 3. System and Equipment Design 6 3.1 System 6 3.2 Fuel Gas Pre-Heater 7 3.3 Fuel Gas Cooler 7 3.4 Fuel Gas Scrubber 7 3.5 Fuel Gas Super-Heater 8 3.6 Fuel Gas Filter Type Separator 8 3.7 Piping Considerations 8 3.8 Control and Shutdown System 9 3.9 Materials 10 4. Definitions 10 5. References 11 Appendices Appendix A. Fuel Gas Conditioning System Design Methodology Fuel Gas System Design Guide ii KS-PR-DEG-0157 Rev 0 01 December 2019 1. Introduction 1.1 Scope This standard covers the design of fuel gas systems for oil and gas production installations. The system boundaries assumed in the standard are given in Figure 1 below: Figure 1: Main Fuel Gas System Boundaries 2. System Description 2.1 Introduction The primary goal of a fuel gas system is to provide a reliable and safe supply of fuel gas of the required specification to the