WorleyParsons 沃利帕森斯设计指南 KS-PR-DEG-0142 Process Simulation Design Guide.pdf

Process Simulation Design Guide Document No: KS-PR-DEG-0142 Rev 0 01 December 2019 © Copyright 2019 Worley ACN 096 090 158. No part of this document or the information it contains may be reproduced or transmitted in any form or by any means electronic or mechanical, including photocopying, recording, or by any information storage and retrieval system, withou t permission in writing from Worley. Table of Contents 1. Introduction 3 2. Scope 3 3. Simulations and Process Design 3 3.1 Feed Conditions and Product Specifications 4 3.1.1 Special Feed Conditions 4 3.1.2 Product specifications 4 3.2 Recommended Property Packages and Methods 5 3.3 Oils and Hypotheticals 7 3.4 Distillation Modelling 8 3.5 Other Equipment Modelling 8 3.6 Sensitivity Cases 8 3.7 Simulation Layout and Output 8 3.7.1 Flowsheet Layout 8 3.7.2 Simulation Output 9 3.8 Simulation Checks 9 4. Definitions 10 5. References 10 Appendices Appendix A. Sample Calculation Table of Contents Process Simulation Design Guide ii KS-PR-DEG-0142 Rev 0 01 December 2019 1. Introduction This Process Design Guide is intended for use as a tool in the organization of Process Engineering. It is not normally issued on a project, however documents based on it, such as process heat and material balance and calculation report may be issued. 2. Scope This document provides high level guidance for the development and documentation of steady state process simulations using commercial packages such as but not limited to Aspen Hysys, Aspen Plus, Unisim, Prosim, and ProMax. Whilst the key focus of this simulati