WorleyParsons 沃利帕森斯设计指南 KS-PR-DEG-0192 Steady State Heat Loss of Stagnant Fluid Design Guide.pdf

Steady State Heat Loss of Stagnant Fluid Design Guide Document No: KS-PR-DEG-0192 Rev 0 01 December 2019 漏 Copyright 2019 Worley ACN 096 090 158. No part of this document or the information it contains may be reproduced or transmitted in any form or by any means electronic or mechanical, including photocopying, recording, or by any information storage and retrieval system, without permission in writing from Worley. Table of Contents 1. Introduction 3 2. Scope 3 3. Overview of Design Guide 3 4. Environmental Heat Transfer Coefficient 4 4.1 Air Side Convection Heat Transfer 4 4.2 Air Side Radiant Heat Transfer 5 5. Calculation Approach 7 5.1 Stagnant Fluid in Pipelines 7 5.2 Stagnant Fluid in Equipment Items 8 5.3 Natural Convection Considerations 8 6. Overall Evaluation of Heat Loss 9 7. Definitions 12 8. References 14 Steady State Heat Loss of Stagnant Fluid Design Guide ii KS-PR-DEG-0192 Rev 0 01 December 2019 1. Introduction This Design Guide is to be used in conjunction with Equipment Heat Loss Calculation KS-PR-CAL-0006 and Pipe Heat Loss Calculation KS-PR-CAL-0007. Other heat loss tools or software may apply slight variations on the theory or calculation approach. This Process Design Guide is intended for use as a tool in the organization of Process Engineering. It is not normally issued on a project, however documents based on it, such as process calculation records or datasheets, may be issued. 2. Scope The purpose of this Design Guide is to provide guidance for evaluation of steady state heat loss from stagnant fluid. It is intended to provide the user with a best practice view, but it is the duty of the user to make all efforts to confirm the content meets (or exceeds) the global industry st