关于电力电缆载流量试验温度测量方法的研究.pdfVIP

关于电力电缆载流量试验温度测量方法的研究 张书鸿 何光华 （上海三源公司 201206 ， 无锡供电公司，214000） Study Study on on Temperature Temperature Measurement Measurement Method Method of of Power Power CaCabble le SStudy tudy on on Temperature Temperature Measurement Measurement Method Method of of Power Power CabCable le Current—Current—Carrying Capacity TestCarrying Capacity Test CurrentCurrent——Carrying Capacity TestCarrying Capacity Test ZHANG Shu-hong1 ， HE Guang-hua 2 （1、Shanghai Sanyuan Cable Attachment Co., Shanghai 201206,China 2、Wuxi Electric Power Co., Wuxi 214000,China） Abstract: Abstract: The paper introduced the 中温度的测量是关键，尤其是导体温度的测 Abstract: Abstract: research and test of the temperature 量，其精度将影响整个试验的准确性，必须 measurement of Power Cable Current — 选择合适的元件和合理的测量方法使得精 Carrying Capacity Test in duct laying. 度满足要求。 The selection and operation of cable 1 测温元件及其系统的选择1 测温元件及其系统的选择 1 1 测温元件及其系统的选择测温元件及其系统的选择 temperature measurement system was also introduced .The accuracy and 电力电缆测温元件的使用环境与条件： interference for sensor measurement was 温度测量范围环境温度至 90 度；电缆排管 tested .The influence of installation 模型取无锡地区最恶劣情况：为 3×9敷设， method on accuracy of temperature 共 27 根管道，中间 3 根空置。因此预计测 measurement was narrated. Finally, the 温点约 320个，其中排管与混凝土交界面 96 notice points for this sensor in actual 个，电缆线芯与护套 216个，其余为土壤及 application were introduced . 其与混凝土浇注体交界面 8 个。线芯测温为 Keywords:Keywords: power cable, Current—Carrying 主要测温点，其它作为参考点。测温元件需 KKeywords:eywords: Capacity, temperature measurement 长期工作约 6 个月；电缆测温点到控制室计 摘 摘 要要：：本文主