自行走式隧道施工中装配式塑料管道合理支护形式试验研究.pdfVIP

钎 建廉 全国中文核心期刊 宜行走式隧道施工中装配式塑料管道 合理支护形式试验研究 卢清国，孙博，王庆学 (北京工业大学 建筑工程学院，北京 100124) 摘要：采用装配式塑料管道为新型自行走式隧(管)道施工提供配套支护技术，需要研究管道的支护强度、管道变形等相关参 数。将整体聚乙烯 (PE)中空壁缠绕管沿管壁轴向切割成片，再焊接拼装成环。选择管道周向的分片数 目和拼装角度作为试验的2个 因素，采用双因素实验方法，并参考管道环刚度测试方法，在环刚度试验机上对分片拼装后的管道进行承压实验 。以塑料管道在径 向变形最大达到 15％时的承载力为承载极限，经对实验结果分析后选出合理的管道拼装分片数 目和角度 。结果表 明，拼装角度对强 度的影响最为显著，分片数 目次之。合理支护形式为：管道周向均分成4片，并将 4条分割缝分别置于与水平和铅垂方向旋转45。的 位置 。 关键词：自行走式隧道掘进；塑料管道；分片拼装；分片数目；拼装角度 中图分类号：TU532+．61 文献标识码：A 文章编号：1001—702X(2010)01—0075—05 Experimentalstudieson rationalsupportform ofprefabricated plastic pipe in self-driveadvancing construction LUQingguo，SUNBo，WANGQingxue (CollegeofArchitectureandCivilEngineering．BeijingUniversityofTechnology，Beijing100124，China) Abstract：Supportingstrength．pipedeformationandrelatedpraameters oftheprefabricatedplasticpipearetobe studied to provide evidence for its application in supportingtechnology during serf—drive advancing construction．Separating the polyethylene (PE)hollow—walltwined pipesaround the axialdirection circumferentialinto slices，and welding into annular．Then，the numberof slicing and theangleofassemb lingare chosen as the experimental influence factors．According todualfactors testapproach，with the reference to the detemr ination method of ring-stiffness，pressure testis conducted on the assemb led pipesby ring—stiffness testing machine．When the plastic pipeS radialdefomr ation max to 15％ ，reasonable segmentnumberand assembly angelare se- lected through comparing and analyzing the testresults．Results show thatthe assemb ly angle hasthe mostsignificnataffecton strength，while segmentnumbertakesthe secondplace．Thereasonablesupp