倒数计时器系统设计.docVIP

摘 要 本文对基于单片机的数字频率计系统进行了研究。 首先在绪论中介绍了本课题的课题背景、研究意义及完成的功能。本系统是以单片机的基本语言C语言来进行软件设计，51的编程语言常用的有二种，一种是汇编语言，一种是C 语言。汇编语言的机器代码生成效率很高但可读性却并不强，复杂一点的程序就更是难读懂，而C 语言在大多数情况下其机器代码生成效率和汇编语言相当，但可读性和可移植性却远远超过汇编语言，而且C 语言还可以嵌入汇编来解决高时效性的代码编写问题。综合以上C 语言的优点，我在编写本系统程序时选择了C 语言。正文中首先介绍了系统的总体设计思路，然后简单描述系统硬件工作原理，且附以系统硬件设计框图；接着具体描述了系统的软、硬件设计，仿真结果，误差分析；最后对本次设计做出了简单的总结、并且提出一些教学建议，文档还附上了本次系统设计的电路原理图、PCB图及元器件清单。本文撰写的主导思想是软、硬件相结合，以硬件为基础，来进行各功能模块的编写。 关键词：单片机 编程 系统设计 ABSTRACT In this paper, based on single chip digital frequency meter systems were studied. First described in the introduction the subject of this topic background, research significance and complete functions. The system is based on SCMs basic language C language for software design, programming language commonly used in 51 there are two, one is in assembly language, one is the C language. Assembly language code generation highly efficient machine readable, but they are not strong, complex process that is even more difficult to read, while the C language, in most cases, the efficiency of its machine code generation and assembly language equivalent, but readable and portability is far more than assembly language, but can also be embedded in C language compilation to solve the time-sensitive nature of coding problems. To sum up the advantages of C language, I am in the preparation of the system selected C language program. First introduced the system in the body of the overall design idea, and then a brief description of system hardware works, and attached to the system hardware design block diagram; then specifically describes the systems software and hardware design, simulation results, error analysis; Finally, to make this design a simple summary, and some teaching suggestions, the document is also attached to this sub-system design, circuit schematics, PCB drawings and parts lists.This article written by the leading idea is that hardware and software combined with hardware-based, to the preparation of various functional modules. Ke