机械毕业设计（论文）-车床组合夹具设计【全套图纸】.doc

本科毕业设计(论文) 题目：夹具设计 系 ： 专 业： 班 级： 学 生： 学 号： 指导教师： 年月  全套图纸，加153893706 Lathe modular jig and fixture design Abstract According to six localizations principles and selection principle of the localization datum, using the long V block, the supporting block and the localization comes true the hard localization. The long V block putted in the arch ribbed plate to limit two degrees of freedom in the x axis and the z axes two degrees of freedom, the iron putted in the hole end limit to the degree of freedom which circle the y rotation of axis, the supporting block putted under the ribbed plate to limit degree of freedom along the y axis migration. Position error is reckoned by the correlation principle. According to the way of the selection principle, discharge head and V block is selected to clamp the part. Then computation of the strength is achieved by carrying on through the cutting force clamps. The power of clamps is from the hydraulic unit. Design of bridge piece is according to the location part and the clamp part. The guide part designing in this topic is not requested because the cutter bar is short. Other parts and equipment are designed following last process. The jig overall arrangement and concrete structure of the body clamp are determined with the above part and the equipment. The position of the components in the kits specific location must be guaranteed, and then design the jig, carry on the working procedure precision analysis. The design review is following. Finally the jig assembly drawing is achieved. Keywords: Modular jig and fixture; location; clamp; union tee 目 录 1绪论…………………………………………………………………………………1 1.1概述…………………………………………………………………………………1 1.1.1车床夹具的分类………………………………………………………………1 1.1.2夹具的组成……………………………………………………………………2 1.1.3夹具体…………………………………………………………………………3 1.1.4车床夹具在机械加工中的作用………………………………………………3 1.1.5车床夹具在车床中的地位及作用…………………