响应面法优化湿式氧化处理阳离子红X_GRL废水.pdfVIP

40 11 浙 江 大 学 学 报( ) Vol.40 o. 11 2006 11 Journal of Zhejiang University(Engineering Science) ov. 2006 X-GRL 戴启洲, 周明华, 雷乐成 ( , 310027) : X-GRL , pH 5, 60~ 180 e 0~ 2 100~ 700 r/ minpH 2~ 10500~ 2 931 mg/ L , . ,. ,, X-GRL , 100%. : ; X-GRL;; : X703 : A : 1008 973X(2006) 11 1889 06 Optimization of wet air oxidation of cationic red X-GRL wastewater by response surface methodology DAI Q-i zhou, ZHOU Ming-hua, LEI Le-cheng (I nst it ute of E nv ir onmental E ng ineer ing , Zhej iang Un iv er sity , H ang z hou 310027, Ch ina) Abstract: Response surface methodology ( RSM) was used to model and optimize the wet air oxidation process using one azo dye cationic red X-GRL as model pollutant. Mono-factor experiments were carried out to select the relatively important factors, based on which the process was optimized by RSM under the following conditions: 60~ 180 e , 0~ 2 stoichiometricoxygen amount, 100~ 700 r/ min agitating rate, pH 2~ 10 and 500~ 2 931 mg/ L pollutant. T hen the optimized model was achieved and the interactions be- tween theoperation factors were systematically discussed. Additional experiments wereperformed to check the model, which showed that the predicted values agreed well with the experimental results. Almost 100% of the dye removal rate was obtained under the optimized operation conditions by RSM. Key words: wet air oxidation; cationic red X-GRL; process optimization; response surface methodology ,2002 [4] 30% , . . WAO , , , [5-6] ,. , ( wet air oxidation, WAO) ., , [ 1-3]