网络营销第2次机实训报告.docVIP

2010上期网络营销第2次上机实训报告 班级 网营班 学号 10020601037 姓名 张春勇 实训任务： 分别访问八个网络营销站点（见上机安排），仔细分析各自网上营销的侧重点、方法和手段，请结合自己的理解填写下表，如所留空格不够，请自行拉大并编辑。 注意：完成后请用电子邮件“附件”的形式发到yxczju@yahoo.cn，其中，邮件的标题和附件（word文档）的名称均应为：**班##号EM第二次上机作业。 一、八家网站网上营销的侧重点 网站名称 网上营销的侧重点 预期目的 河南移动 最主要的是体现到——简便、快捷，详细的查询服务1 、 为订单而采购，消灭库存2 、双赢，赢得全球供应链网络3 、实现三个 JIT （ just in time 即时），即 JIT 采购、 JIT 配送和 JIT 分拨物流的同步流程施的是一次经用户许可的、采用外部列表的、经营性的EMAIL营销当当网所使用的网络营销方法有：无站点网络营销方法和基于企业网站的网络营销方法。网络会员制营销，即网站联盟。他是一种网络会员制的营销，他将商家的分销渠道扩展到各个角落，同时为会员提供了一个简易的赚钱途径。而世界上最好的营销就是，让你的客户和你一起赚钱，这样他才会更加的热衷于帮企业营销。 appearance of the weld appearance quality technical requirements of the project must not have a molten metal stream does not melt the base metal to weld, weld seam and heat-affected zone surface must not have cracks, pores, defects such as crater and ash, surface smoothing, weld and base metal should be evenly smooth transition. Width 2-3 mm from the edge of weld Groove. Surface reinforcement should be less than or equal to 1 + 0.2 times the slope edge width, and should not be greater than 4 mm. Depth of undercut should be less than or equal to 0.5 mm, total length of the welds on both sides undercut not exceed 10% of the weld length, and long continuous should not be greater than 100 mm. Wrong side should be less than or at 0.2T, and should not be greater than 2 mm (wall thickness mm t) incomplete or not allow 7.5 7.5.1 installation quality process standards of the electrical enclosure Cabinet surface is clean, neat, no significant phenomenon of convex, close to nature, close the door. 7.5.2 Cabinet Cabinet face paints no paint, returned to rusted, consistent color. 7.5.3 uniform indirect gap from top to bottom, slot width 1.5mm 7.5.4 adjacent Cabinet surface roughness is 0. 7.5.5 the cabinets firmly fixed, crafts beautiful. 7.5.6 Cabinet surface gauge, switch cabinet mark clear, neat, firm paste. 7.5.7 Terminal row of neat, is reliable, the appearance is clean and not damage