guidance document1998-12-23 b a a q m d inspection procedure g d f（指导document1998-12-23 b问m d g d f检验过程）.doc

下载文档 降价啦

1
0
约9.77千字
约 6页
2017-01-18 发布于湖南
举报
版权申诉
保障服务

guidance document1998-12-23 b a a q m d inspection procedure g d f（指导document1998-12-23 b问m d g d f检验过程）.doc

1、本文档共6页，可阅读全部内容。
2、原创力文档（book118）网站文档一经付费（服务费），不意味着购买了该文档的版权，仅供个人/单位学习、研究之用，不得用于商业用途，未经授权，严禁复制、发行、汇编、翻译或者网络传播等，侵权必究。
3、本站所有内容均由合作方或网友上传，本站不对文档的完整性、权威性及其观点立场正确性做任何保证或承诺！文档内容仅供研究参考，付费前请自行鉴别。如您付费，意味着您自己接受本站规则且自行承担风险，本站不退款、不进行额外附加服务；查看《如何避免下载的几个坑》。如果您已付费下载过本站文档，您可以点击这里二次下载。
4、如文档侵犯商业秘密、侵犯著作权、侵犯人身权等，请点击“版权申诉”（推荐），也可以打举报电话：400-050-0827(电话支持时间：9:00-18:30)。

Inspection Procedure GDF-03 Gasoline Dispensing Facilities PRESSURE INTEGRITY PERFORMANCE vERIFICATION FOR VACUUM ASSIST SYSTEMS [Squeeze Bulb Test] 1. PURPOSE 1.1 Air ingestion caused by a leaking nozzle or vapor check valve degrades vapor collection during vehicle refueling and increases pressure-related fugitive emissions by promoting gasoline evaporation in the vapor recovery system. This inspection procedure provides a method to determine if “bootless” Phase II vacuum assist vapor recovery nozzles or remote vapor check valves allow air ingestion into the vapor recovery system. The procedure is applicable to those bootless systems that utilize a remote vapor check valve; it is not applicable to systems that utilize nozzles with built-in check valves. The procedure is designed to produce virtually no testing-related emissions. When used in conjunction with Inspection Procedure GDF-01 (Bag Test) this procedure can isolate certain sources of air leakage. 2. Principle 2.1 A compression fitting, or Air-to-Liquid (A/L) adaptor is placed over the nozzle spout, isolating all of the vapor collection holes. A squeeze bulb is used to create a vacuum of fifteen (15.0) plus or minus one ((1.0) inches H2O at the vapor collection holes on the nozzle spout. A toggle valve is closed, isolating the squeeze bulb and eliminating it as a possible decay source. A pressure/vacuum gauge, connected to the test assembly is used to determine the rate of vacuum decay. If the vacuum decreases by more than one (1.0) inch H2O in ten (10) seconds, there is an unacceptable leak between the nozzle spout and the remote vapor check valve, inclusive. 3. Interferences 3.1 If the nozzle spout is deformed such that the vapor collection ports cannot be isolated, the inspection procedure will be biased to indicate noncompliance. 3.2 This procedure cannot be used on passive systems such as a balance system. 4. EQUIPMENT 4.1 Pressure Integrity Assembly. Use a compre