ppt课件-2009 uniform plumbing code presentation（2009年统一管道代码演示）.pptVIP

* * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * Grease in PVC Pipe * * Grease in lift station * * * * * * * * * * * * * * * The Gravity Grease Interceptor design type incorporates two or more compartments in series, a minimum volume of 500 gallons and uses its larger volume of water to slow the flow velocity down allowing the time required for simple buoyancy of grease, FOG (fats, oils and grease) in water to cause separation. That is why the physical size of the Gravity Grease Interceptor is so much greater than the physical size of the Hydromechanical Grease Interceptor. With both design types the key to proper sizing is understanding the “Size” nomenclature since it is different for each type. The size of a Gravity Grease Interceptor is based on the actual volume of water the interceptor will hold expressed in gallons. Common Sizes available today are 500, 750, 1000, 1250, 1500, 2000, 3000 Gallons The discharge from food grinders (garbage disposals) is almost universally required to bypass the grease interceptor. The food grinder (and the associated pre-rinse station at the dishwasher ) is one of the single greatest sources of FOG. Yet despite that fact, most codes forbid food grinders discharge from passing through a grease interceptor. Technologically there is no reason for the waste stream to bypass the grease interceptor if the solids have been removed. Chapter 11Storm Drainage Chapter 11, Storm Drainage a. The board does not adopt Chapter 1101.5, Subsoil Drains. b. The board does not adopt Chapter 1101.6, Building Subdrains.. c. The board does not adopt Chapter 1101.7, Areaway Drains. d. The board does not adopt Chapter 1101.8, Window Areaway Drains. e. The board does not adopt Chapter 1101.9, Filling Stations and Motor Vehicle Washing Establishments. f. The board does not adopt Chapter 1101.10, Paved Areas. g. The board does not adopt Chapter 1102.5, Subsoil Dr