软材压缩包装液压回路设计与插装阀有限元分析.pdfVIP

10 捷总毒气动 2014 年第 6 搁 doi : 10. 11832/ j. issn. 1000-4858. 2014.06. ∞3 软材压缩包装液压回路设计与插装阀有限元分析 刘勇军1 气范晋伟1 ( 1. 北京工业大学机械工程与应用电子技术学院，北京 1∞124; 2. 销壁职业技术学院机电工程学院，河南鹤壁 458的0) 摘 要:软质材料通常采取压缩包装的形式进行储存和运输，该研究设计了一种基于插裴间的软质材料 压缩包装的液压回路，该回路可以实现空行程快速下降、压缩时正常速度下降、捆扎时低速下降、捆扎完毕后 快速上升的功能，并且在活塞杆和压头停止运动时能够保压。对插装间的间决进行了有限元分析，结果显示 间块满足结构强度要求。 所设计的液压回路已经应用在纤维的压缩包装中.效果良好。 关键词:软质材料;包装;液压回路;插装阀;陀M 中图分类号:四1 37 文献标志码:B 文章编号: 1α)()-4858 (20 14) 06-00 10-03 Design of Hydraulic Circuit for Soft Materials Compression Molding and FEM Analysis of Cartridge Valve UU Yong-jun 1.2 ,FAN Jin-wei 1 (1. Sch∞I of Mechanical Engineering and Applied Electronics Technology , Beijing University of Technology , Beijing 1∞124; 2. Sch∞1 of Mechanical and Electrical Engineering , Hebi Col1ege of V∞ation 四d Technology , Hebi , Henan 458030 ) Abstract: 50ft materials are usually compressed and baled for store and 回nsport. A hydraulic circuit based on Car- tridge valve is designed to compress and bale 50ft materials. By this circuit , to fall quickly in idle , normally in compression , slowly in binding and to rise quickly in retum can be achieved . The oil pressure can be maintained when the piston is in halt.币le block of cartridge valve is analyzed by the finite element method (FEM) and the re- sults show that the structure intensity meets the 陀quirements. 币le circuit has been applied ω由e compression of fi- bers and the system runs well. Key words : 50ft materials , packing . hydraulic circuit , cartridge valve. FEM 滑。 由于压缩液压系统流量大，所以使用了插装阀，