管螺纹的标准(国外英文资料).docVIP

管螺纹的标准(国外英文资料) The standard of pipe threads: Pipe thread: mainly used for the connection of the pipe, which makes the inside and outside threads fit tightly, and there are two kinds of direct tube and cone pipe. Common pipe threads include the following: NPT, PT, G, etc. 1: the NPT thread is 60 degrees American standard taper pipe thread 2: PT BSPT thread is Europe and the commonwealth 55 degrees sealed tapered pipe threads 3: G thread is 55 degrees of threaded pipe thread sealing 4: mid-december, thread is 1) the NPT is an abbreviation of National (American) PipeThread, which belongs to the American standard 60 degree spinal thread, used in North America, and the National standard is referred to GB/t12716-1991. 2) PT (BSPT) is the abbreviation of PipeThread, thread is 55 degrees seal round vertebra canal, belong to wyeth thread family, for Europe and the commonwealth countries, often used in water and gas pipe industry, taper 1:16, national standard refer to GB/T7306-2000. The domestic name is ZG. 3) G is 55 degrees non-threaded sealing pipe threads, belonging to the wyeth threads family. Mark G for cylinder. GB/T7307-2001. The difference between metric and English thread: The metric thread is used to indicate that the American and British threads are represented by the number of threads per inch. The metric thread is 60 degrees equilateral tooth type, the English thread is the isosceles 55 degree tooth type, the beautiful thread is equal waist 60 degree tooth type. The metric thread is made of metric units (such as mm), and American and British threads are made of British units (such as inches). People in the line usually use minutes to address the size of a thread, an inch is equal to eight points, a quarter of an inch is two, and so on. Also: ISO - metric thread standard 60 degrees; UN - unified thread standard 60 degrees; API - U.S. petroleum pipe thread standard 60 degrees; W - British whitworth thread standard 55 degrees; NPT BSP thread technology - the NPT,