串口SATA硬盘驱动及安装问题大全（国外英文资料）.doc

串口SATA硬盘驱动及安装问题大全（国外英文资料） Serial port SATA drives and installs the problem How to install XP system of serial port hard disk boot XP disk into the A critical step is when you have the first blue image and there is a hint of F6 on the bottom of the frame and then you press it to do the drive load of the serial port There are hints to follow The following is the same as a regular hard drive Note: First, you need to see if your main board supports SATAs hard drive. I also went to a hard disk, installed system, cant start, but cant find the hard disk, then the specification is not relevant guidance, had to call the motherboard manufacturer and reply is this motherboard supports SATA hard disk, but does not support this kind of hard disk boot, had to give up. SATAs hard drive will be able to install the XP system on the VIA chip by loading SATAs driver with a floppy disk. Can the serial port hard drive use ghost In general, the serial disk drives can be backed up and restored using GHOST. If you are using blue screen and die machine, please change the BIOS Settings in the following way: Enter the BIOS, select the IDE Configuration, and choose Compatible Mode in the Onboard IDE Mode Mode. If not, refer to the following BIOS setup. The following is an example of the ASUS P4P800 motherboard to illustrate the operation: A SATA hard drive hangs on the SATA1 interface, and a CDROM hangs in the PRIMARY IDE interface (set to the main disk) : A) turn on the BIOS Settings and select the IDE Configuration in the MAIN menu B) change the Onboard IDE to Compatible Mode In [Enhanced Mode Support On], [Primary p-ata + s-ata] D) restart after entering the BIOS, you will find in the MAIN menu, only four IDE devices [Primary IDE MASTER] to [CDROM], [Primary IDE Slave] to [NONE], [Secondary IDE MASTER] to [IDE DISK] (your hard DISK model), [[Secondary IDE Slave] to [NONE] A SATA hard drive hangs on the SATA1 interface, a CDROM on the SECONDARY IDE interface: As long as the third step in the