基于接触力学的圆柱滚子轴承刚度对印刷压力的影响分析.pdfVIP

研究论)c 中国印刷与包装研究 2010年第l 期(第2~是) RESEARCH PAPERS CHINA PRINTING AND PACKAGING STUDY Vo l.02 No .l 2010.02 基于接触力学的圆柱滚子轴承刚度对 印刷压力的影响分析 陈瑞礁，张悔燕 (西安理卫大学印刷包菇工程学院，西安 710048) 摘要 以对开胶印机使用的轴承NNU4922-8-K - M…S为研究对象，幕于接触力学理论，计算圆柱梅子轴承的静 态就荷分布政刚度，分析了静态载荷分布1ft. 刚度与径向游隙、外加径向载荷的关系，利用有限元软件ANSYS建 立J3!印梅简模型，分析圆柱楼子轴或静态刚度对应印攘筒挠度的影响。研究表明t 随着游隙的增大，最大负荷增 大，铀承刚度喊小，梅筒变形量增大，~结果是引起印刷压力下降。 关键词 圆柱梅子轴承s 刚度$挠度，印刷压力 中图分费号 TH133.33 文献标识明 A 文章编号 1674-5752(2010)01-08-05 Aoalysis of the Inßueoce of the Rigidity of Cyliodrical Roller Bearing 00 Priotiog Pressure Based 00 Cootact Mechaoics CH巴N Ruiyan , ZHANG Haiyan (The Faculη， ofPrinting and Packaging Engineering ,X ian University ofTechnology, Xian 71ω咽， China) Abstract In 伽is paper , the cylin命ica1 roller bearings static load distribution and the rigidity had 民en ca1culated based on the theory of contact mechanics , taking type NNU4922δ-K翩M翩SP bearing using in offset printingωan example. 啊le relation 拟nong the static load dístribution , the rigidity and the radía1 wíndage and the external radia1 10ad are ana1yzed. The impression cylinder model is established by the ANSYS. The influence of the static rigidity of cylindrica1 roller bearing on the impression cylinders deflection is a1so analyzed. 币le results show that with windage increased , the maximal load increases , the bearing rigidity reduces，削d the deformation of cylinder incre创时， which will cause 加printing pressure to be insufficient. Key words Cylindrica1 roller bearing; Rigidity; Deftection; Printing pressure 印刷单元的重要部件，其作用是承载负荷，将撩筒在 o 51 富 轴向和径肉在位，确