酚醛板外墙外保温施工工艺（国外英文资料）.docVIP

酚醛板外墙外保温施工工艺 This article is contributed by wangxiaoleibbm DOC documents may experience poor browsing on the WAP side. It is recommended that you first select TXT, or download the source file to the local view. External wall insulation system of phenolic resin board Construction scheme Shanghai Ya Chun Decoration Engineering Co., Ltd. Shanghai Yada special coating Co. Ltd. 2011329 Construction technology of phenolic resin board for PF external wall external thermal insulation (I) One Construction preparation Base wall Grassroots wall should be consistent with the building decoration decoration quality acceptance specification, GB50210 standards, metope Loose, dust, dirt and stripping agent clean up, the wall roughness is too bad, some should be offset or repaired, protruding out of the wall (equipment, pipes) connector has been installed. The dimension deviation of the surface of the wall shall be in accordance with the provisions of table 1. Table 1 wall surface allows the size deviation of each layer of the vertical wall project of masonry engineering of high surface roughness less than 5m layer perpendicular to the wall surface roughness of concrete worker Cheng Quangao H/1000 and less than or equal to 308 theodolites, check the 2m ruler and ruler feeler check 5m 10 5 high Zha theodolite or sling, check check ruler 10m 208 2m ruler and ruler 10m 10 theodolite or hanging ruler inspection allowed deviation is less than or equal, mm 5 test method of 2m supporting board inspection In the light wall construction or the existing building for external thermal insulation, it is necessary to check the external insulation wall surface. Through calculation and verification, confirm the adhesive strength of the phenolic resin adhesive. F=B * S = 0.10N/mm2, the bond strength of F---- (N/mm2) B---- base wall and the measured bond strength of S---- bonded area phenolic plate adhesive rate base wall for concrete wall, concrete perforated brick (block), and the influence of str