钢筋加工（国外英文资料）.docVIP

钢筋加工 Steel processing.Txt49 rocks because of conviction, it aroused the beautiful waves; youth because of the pursuit of lofty, only exceptionally bright and colorful. 50 because young, so self-confidence; because of self-confidence, so young. This article is contributed by Liu Tiefeng 121213 DOC documents may experience poor browsing on the WAP side. It is recommended that you first select TXT, or download the source file to the local view. Construction technology of reinforcing bar All the cast in place box girders are fabricated in reinforced concrete workshop. Carry the car to the construction site for installation (longer welding or lap joint). Steel work is characterized by more processing processes, steel straightening, cutting, rust removal, bending, welding or banding molding. In view of the quality of steel processing and special (layout, installation, concrete placement can not be checked), it is necessary to carefully and strictly control the quality of steel processing processes. A test approach of reinforced materials comes into play, by the Central Laboratory of the quality index to conduct a comprehensive inspection according to the number of selected specimens yield strength, tensile strength, elongation and bending test, its quality should be consistent with current national standard reinforced concrete hot-rolled round steel bars (GB13013), the reinforcement of concrete hot rolled ribbed bar (GB1499) and low carbon steel wire rods (GB/T701) and other provisions and requirements. Inspection quantity: with the same grade, the same furnace number, the same specifications, with the delivery of the state of steel, each 60t for a batch of less than 60t, also according to a number of calculations. Each batch is checked once. When sampling, notify the supervising engineer to witness sampling inspection or parallel inspection. Two, steel storage, steel processing site all hardening treatment, all the reinforcing steel raw materials are 50 cm high shelf, an