夏普复印机故障代码（SHARP copier fault code）.docVIP

夏普复印机故障代码（SHARP copier fault code） 1, F2 fault, F2 fault code display is the more common phenomenon of this machine. There is also a problem with the copy when it comes out with the F2 code. The main problems of the photocopies are as follows: (1) the copies are all white. (2) the copies are all black. (3) the copy is in the direction of the paper, the first half is black, and the latter is white. (4) the copy is brief. According to the F2 code of the different side of the F2 fault reason analysis as follows: (1) F2 - 31 code shows the operation way of checking when the F2 code appears in the information on the screen, press the copy button, then appear on the screen of F2-31 display, can be judged as F2-31 fault. At the same time, copy operations can be carried out to check the quality of the copies. Under normal circumstances, the copy appears as one of the four problems mentioned above. The cause of the failure) 1) image concentration sensor (ID) pollution. 2) drum surface cleaning is not good, still sticky with a certain amount of toner. 3) the image concentration sensor (ID) is damaged. 4) image concentration sensor (ID) circuit board fault. 5) imaging control of VR circuit board faults. 6) the side lamp is not good. 7) DC power supply panel fault. 8) main board fault. 9) the wiring harness is broken. 10) poor contact with the plug. 11) the use of non genuine supplies. (2) F2-32 code display (with the F2-37) operation check mode, press the copy key when the F2 code appears on the information display screen. At this point, the F2-32 display appears on the screen. Can copy operation, check the quality of the copy, in general, the copy of the aforementioned copy of the four problems. Can be judged to be F2-32 fault. Causes of malfunction) 1) drum marking sensor (DM) pollution. 2) drum surface cleaning is not good, still sticky with a certain amount of toner. 3) drum marker sensor (DM) level adjustment is incorrect. 4) drum marker sensor (DM) damage. 5) drum wear b