ttl电平和coms电平（TTL level and COMS level）.doc

ttl电平和coms电平（TTL level and COMS level） TTL Essential information The TTL level signal is used most often because the usual data representation is binary, +5V is equivalent to logic 1, and 0V is equivalent to logical 0 Known as the TTL (transistor transistor logic level) signal system, this is the standard technology for communication between the various parts of the device controlled by the computer processor. The TTL level signal is ideal for data transmission within a device controlled by a computer processor, first of all, data transmission within the device controlled by the computer processor The loss of the power supply is not high and the heat loss is low. In addition, the TTL level signal is directly connected to the integrated circuit without the need for expensive circuit drivers And the receiver circuit; moreover, the data transmission within the device controlled by the computer processor is carried out at high speed, and the operation of the TTL interface can satisfy this Requirement。 TTL type communication uses parallel data transmission in most cases, while parallel data transmission is not suitable for distances of over 10 feet. this Due to both reliability and cost. Because of the presence of bias and asymmetry in parallel interfaces, these problems have an impact on reliability. In digital circuits, the level used by a circuit consisting of TTL electronic components. The level is a voltage range, which specifies the output high level 2.4V and the output low level 0.4V. At room temperature, the general output is 3.5V high and the output low is 0.2V. Minimum input high and low: input high level =2.0V, input low power Flat =0.8V, noise margin is 0.4V. The full name of the TTL integrated circuit is the transistor transistor logic integrated circuit (Transistor-Transistor Logic), mainly 54/74 series Standard TTL, high speed TTL (H-TTL), low power TTL (L-TTL), Schottky TTL (S-TTL), low power Schottky TTL (LS-TTL) Five series. Standard TTL input high, min