dynamic stress-strain behaviour of steel fiber reinforced high-performance concrete with fly ash钢纤维增强高性能混凝土的动态应力-应变行为与粉煤灰.pdfVIP

Hindawi Publishing Corporation Advances in Civil Engineering Volume 2012, Article ID 907431, 6 pages doi:10.1155/2012/907431 Research Article Dynamic Stress-Strain Behaviour of Steel Fiber Reinforced High-Performance Concrete with Fly Ash Tan Chien Yet, R. Hamid, and Mudiono Kasmuri Department of Civil and Structural Engineering, Faculty of Engineering and Built Environment, Universiti Kebangsaan Malaysia, Selangor, 43600 Bangi, Malaysia Correspondence should be addressed to R. Hamid, roszilah@eng.ukm.my Received 2 August 2012; Accepted 18 October 2012 Academic Editor: Paola Bandini Copyright © 2012 Tan Chien Yet et al. This is an open access article distributed under the Creative Commons Attribution License, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited. The addition of steel fibers into concrete mix can significantly improve the engineering properties of concrete. The mechanical behaviors of steel fiber reinforced high-performance concrete with fly ash (SFRHPFAC) are studied in this paper through both static compression test and dynamic impact test. Cylindrical and cube specimens with three volume fractions of end-hooked steel fibers with volume fraction of 0.5%, 1.0%, and 1.5% (39.25, 78.50, and 117.75 kg/m3 ) and aspect ratio of 64 are used. These specimens are then tested for static compression and for dynamic impact by split Hopkinson pressure bar (SHPB) at strain rate of 30–60 s−1. The results reveal that the failure mode of concrete considerably changes from brittle to ductile with the addition of steel fibers. The plain concrete may fail under low-strain-rate single impact whereas the fibrous concrete can resist impact at high strain rate loading. It is shown that strain rate has great influenc