铸型涂料（Mold coating）.docVIP

铸型涂料（Mold coating） Mold coating Xiao Ke is material Inner Mongolia Institute of Technology [Abstract] this paper mainly introduces the function of sand mould (core) coating in improving the surface quality of casting, and points out that the coating is dry Dry method, the different composition is not the same, this paper respectively introduces drying, drying and drying the coating liquid. The coating is a covering of the surface of the core (core) The main object is to improve the surface smoothness of castings, and sometimes to use them To protect the mold (Jin Xing) surface and to change the metallographic structure of the casting (including refined grain) and so on. The material cost of the coating is approximately cast The cost is 1%, and the cost of coating process is the core cost 10%. Production of castings using a coating type (core), cost Improved, but in the proper use of paint, the casting can be Sales (Saleability) increase, that is, in the market Increased competition, casting production has been developed. Its because of the paint The material not only improves the surface quality of castings, but also reduces the cleaning Cost reduces waste and casting defects and produces castings Present decrease. Therefore, coatings improve their own properties and methods of use At the same time, developed. First, the role of paint Coatings are used to improve the surface of castings by the following ways Qualitative: 1. prevent mechanical sand sticking The metal liquid penetrates into the pores between the sand grains, and then the sand is solidified The particles are mechanically bonded to the surface of the casting and are called mechanical grit. Slight penetration results in rough surface. In fact, these two kinds are missing The trap represents the two stage of metal penetration into the sand mold. Dense in casting In case of metal penetration, the casting depth is high in sand radius At this point the metal passes through the void between the pressure and t