Part 16 - Launch and Post Launch SACST 培训教材.pdf

Part 16 - Launch and Post Launch Preparation 1) Under “Training Project”, create “Launch” subdirectory 2) Copy SACINP.DAT model file from “\Tow\Tow Inertia” directory to “Launch” directory. Create Launch input file LNHINP.DAT for jacket launch analysis For Launch options, use MN unit for both input and output; Set “Accel Velocity Disp Plot Type” as NPF for neutral picture file. Input water depth 79.50 m and seawater density as 1.025 MT/m^3. A launch time control TIME line is need. Set stop time to 625.0 seconds, set output time intervals to 10.0, 5.0, 1.0, 1.0 and 5.0 corresponding to phase 1 to 5. Minimum launch time step = 1.0E-8 second and error control parameter =1.0. Jacket Orientation JACKET line will be added to define jacket position relative to barge. Joint 401L, 405L and 101L will be input as 1st, 2nd and 3rd joints. st Distance from barge front to 1 joint = 84.0 m; Length of Launch Framing = 82.0 m; Density of construction material and added load = 7.85 MT/m^3 Barge description will be input on BARGE1 line: Height of barge = 7.50 m; Width of barge = 18.50 m; Bottom Length of barge = 75.0 m; Forward Extension = 5.0 m; Aft Extension =7.50 m; Forward initial draft = 2.25 m; Aft initial draft = 4.50 m; Number of side and bottom increments = 20 Additional Barge description will be input on BARGE2 line: Skid height = 1.50 m; Rocker Pin Location = 84.0 m; Rocker arm depth = 2.75 m; Winch speed = 0.1 m/sec; Both drag and added mas