Part 18 - Motion and Stability SACST 培训教材.pdf

Part 18 -Motion and Stability Preparation 1) Under “Training Project”, create “Motion” subdirectory 2) Copy SACINP.DAT model file from “Launch” directory to “Motion” directory and rename it to SACINP.JACKET. 3) Copy SACINP.DAT model file from “Static PSI” directory and rename to SACINP.DECK. Modifying jacket model file for motion analysis Using Precede, delete jacket top supporting joints 1401, 2401, 1405 and 2405 and related CAN members. Modifying deck model file for motion analysis Using Precede, “File” “Save As” to save a Model only file using the same file name. Delete all the joints and members below Z = 4.00 m, so only deck structure left. Add joint fixities 111111 to joint 601L, 603L, 605L and 607L. Using “Misc” “Check Model” and delete all unused member group labels. Delete all blank load cases attached. Delete Center ID line and weight group LIVE and all jacket weight groups. Create Motion input file TRNINP.DAT for motion/stability analysis For transportation options MOTOPT: MN unit be used with water density = 1.025 MT/m^3 and Water Depth = 79.50 m; Panel non-coplanarity tolerance = 5 deg. Load generation option “WS” will be selected to generate cargo inertia loads; Martec diffraction motion/stability program will be used for stability and wave load generation; Automatic draft and trim calculation will be selected along with viscous damping will be calculated by program. Straight hull offsets selected. For stability options STBOPT: Intact stability selected along with ABS criteria; Damaged compartment ID 6P will be used for damaged stability analysis;