Part 4 - Collapse analysis SACST 培训教材.pdf

Part 4 -Collapse (Pushover) Analysis 1) Under “Training Project”, create “Collapse” subdirectory 2) Copy SACINP.DAT model file, SEAINP.DAT Seastate file and PSIINP.DAT soil data from “Static PSI” directory to “Collapse” directory. Rename the model file to SACINP.CLP and Seastate file to SEAINP.CLP. 3) Modify Seastate file necessary for collapse analysis Delete LCSEL and AMOD lines; Delete operating storm load cases and extreme storm load case S045 and S090; Delete all load combinations; Delete dead load from extreme storm load case S000; Add DEAD load condition with selected weight groups for ANOD and WKWY; 4) Create collapse input file CLPINP.CLP Collapse options: Member segments 8 will be chosen along with 60 iterations allowed for both load increment and member iterations. Joint flexibility and joint strength will be included; Collapse max. deflection = 500 cm will be used with .005 strain hardening ratio. One Load sequence AAAA defined for applying dead loads and then environmental load: Load case DEAD, EQPT, MISC, AREA will be added in one step; Load case LIVE will be added in one step for 50 percent load value; Environmental load S000 will be added in 100 steps for load factor of 5.0. One Load sequence AAAA defined for applying dead loads and then environmental load: Load case DEAD, EQPT, MISC, AREA will be added in one step; Elastic member groups can be defined using GRPELA line for member groups W01, W02, W03, LG7 and W.B. Elastic plate group will be defined for PL1 using PGRELA line. Collapse input file defined shall looks like following: CLPOPT 60 8 60 JF JS 0.100.001 0.01 500. .005 LDSEQ AAAA DEAD 1 1.0EQPT 1 1.0MISC 1 1.0 LDSEQ AREA 1 1.0LIVE 1 0.5S000 100