Part 3 - Static PSI SACST 培训教材.pdf

Part 3 -Static PSI Analysis 1) Under “Training Project”, create “Static PSI” subdirectory 2) Modifying model file for static PSI Analysis From “Structural Modeling” directory copy file SACINP.DAT to “Static PSI” directory. Separating model file from Seastate file for the convenience of future analysis. Copy SACINP.dat to SEAINP.dat; Using Precede program open SACINP.STA, save as “Model Only” file; delete all blank load cases; Using Precede program open SEAINP.STA, save as “Seastate Only” file, select “Use loads in Seastate Only”; 3) Create PSI soil data file PSIINP.DAT. PSI options: “MN” unit will be used with number of pile segments = 100. Soil plot requested using PLTRQ line PSI options line and plot line shall looks like following: PSIOPT +ZMN SM 100 0.5 7.849 PLTRQ SD DAE DTE UCE LG XH Two pile groups will be defined for pile length 39 m each. Pile diameter = 91.5 cm, with 2.5 cm thickness for first 10 m segment and 1.5 cm for second 29.0 segment. End bearing area 0.656 m2 used for both pile groups. Pile groups defined shall looks like following: PLGRUP PLGRUP PL1 91.50 2.500 20.00 8.00 34.50 10.00 PLGRUP PL1 91.50 1.500 20.00 8.00 24.80 29.0 0.656 PLGRUP PL2 91.50 2.500 20.00 8.00 34.50 10.00 PLGRUP PL2 91.50 1.500 20.00 8.00 24.80 29.0 0.656 Piles will be defined using PILE lines for pile head joint, pile group label, batter information and soil data relation. Static PSI - 1 Piles defined shall looks like following: PILE PILE 101P201P PL1 SOL1 PILE 103P203P PL2