使用活性炭—氨工质对的太阳能吸附式制冷系统研究-research on solar adsorption refrigeration system using active carbon - ammonia working pair.docxVIP

  • 3
  • 0
  • 约6.35万字
  • 约 93页
  • 2018-08-01 发布于上海
  • 举报

使用活性炭—氨工质对的太阳能吸附式制冷系统研究-research on solar adsorption refrigeration system using active carbon - ammonia working pair.docx

使用活性炭—氨工质对的太阳能吸附式制冷系统研究-research on solar adsorption refrigeration system using active carbon - ammonia working pair

关键 关键词 太阳能 吸附式 制冷 活性炭 氨 CPC 中文摘要 本文对以活性炭 氨为工质对的太阳能吸附式制冷系统进行了深入研究 考虑到在目前已知的太阳能固体吸附式制冷系统中 选用活性炭 氨作为工质 对的系统具有相对较多的工程应用优点 因此从实用化的角度出发 设计并建 造了一套活性炭 氨为工质对的太阳能吸附式制冷系统 在实验研究的基础上 建立了相应的数学模型 对影响系统性能的参数进行了综合的分析研究 最后 探讨了应用聚焦集热器 CPC 对提高太阳能吸附式制冷系统效率的作用 针对以 上研究的实质内涵 开展了如下的具体工作 1 设计并建造了一套以活性炭 氨为工质对的太阳能吸附式制冷系统装置 吸 附床由 15 根填充了活性炭的无缝钢管组成 有效集热面积为 1.12m2 总共 填充了 15kg 活性炭 系统还包括了冷凝器 蒸发器等部件 该系统的太阳 能模拟光源由国际上标准的石英碘钨灯来替代 通过调节 使实验时的太阳 辐照强度与上海地区 6 月的实际辐照强度相同 系统运行时能方便地监测出 各部件的特性参数 2 在接受一定的日照辐射能量条件下 对所建立的太阳能吸附式制冷系统进行 了多次实验 实验表明 在接受日照辐射 20.5MJ 后 吸附床最终温度可达 115丁左右 系统能将 2.6kg 的水降温 11.5丁 水温最低时可达 0.5丁 系统的 COP 在 0.01 0.02 之间 所获得的制冷量可以满足小型冷藏系统的要求 3 以所建立的实验装置为物理模型 在分析了系统各部件间的热力学关系的基 础上 建立了相应的数学模型 同时根据太阳能吸附式制冷循环的特点 计 算了活性炭 氨为工质对的太阳能吸附式制冷系统在接受一定日照辐射能量 的条件下 吸附床内吸附剂的动态温度分布 将计算结果与同样工况下的实 验结果进行了对比 吻合得较好 4 利用所建立的数学模型 针对所研究的活性炭 氨太阳能吸附式制冷系统 从吸附床的内部特性参数及外部特性参数出发 较为全面而系统地分析了这 些参数的改变对系统性能COP的影响 得出了一些规律性的结论 这为 以后系统的实用化设计提供了基础 5 针对平板式太阳能固体吸附式制冷系统性能较低的现状 对使用聚焦集热器 来提高系统的性能的设想进行了研究 建立了使用 CPC 作为集热器的太阳 能固体吸附式制冷系统的数学模型 对 CPC 集热器在太阳能固体吸附式制 冷系统的应用进行了探讨 Keywords Keywords: solar energy, adsorption, refrigeration, activated carbon, ammonia, CPC ABSTRACT A solar adsorption refrigeration system, in which activated carbon-ammonia is used as working pairs, has been designed and manufactured. The performance of the system has been investigated experimentally. In particular, a comprehensive mathematical model in consideration of the heat and mass transfer process in the adsorbent, has been developed. Some important parameters, which affect system performance, such as contact thermal resistance, thermal conductivity of the adsorbent, and heat capacity of the metal, were discussed in detail. In order to lift the temperature level of the adsorption bed and improve the system performance, a particular system using CPC is presented and analyzed. The main works are summarized as following: The system is configured by solar adsorber, condenser, evaporator, cold storage box and vales, etc. The solar adsorber is composed of 15 stainless s

您可能关注的文档

文档评论(0)

1亿VIP精品文档

相关文档