充气电缆气压监控系统的设计-控制工程专业论文.docxVIP

THE AIR PRESSURE MONITORING SYSTEMS DESIGN IN GAS FILLED CABLE ABSTRACT With the telephone more widely used in a city, more and more communications cables are laid down.Meanwhile work payload of maintainers in communication cable maintaining become larger and larger.It is because that inflation method is commonly used to prevent cable from moistening and enhance insulation strength.Commonly, a local office layout inflation equipment and charge cable with dry air to keep pressure in the cable.In a medium sized city, the local office need layout 20~30 cables with more than one thousand cores for each cable.The length of these cables are more than 4 kilomaters. So it is necessary to keep pressure for these cable charged with air.To judge whether cable is damaged, maintainers need measure the pressure of each cable.Because of the coverage area of cable network, it is a hard work to measure pressure by mannual.To relieve to work payload of maintainers and promote the efficiency, kinds of remote measurement system for cable pressure are used by telecommunication company.To relieve to work payload of maintainers and promote the efficiency, kinds of remote measurement system for cable pressure are used by telecommunication company.With this kind of equipment, the cable pressure of several hundred control points can be measured within several minutes.With this kind of equipment, the cable pressure of several hundred control points can be measured within several minutes.By this way, not only the status of pressure can be under of control in time, but also distribution curve of the pressure can be drawn to judge the location of gas-leaking.If the console is added for the remote measurement equipment and digital/analog convertion circuit is configured, distribution curve can be displayed on the screen directly. It is so convenient for maintanence.So the remote measurement equipment of cable pressue is developed in our company to relieve the work payload of maintainers. The sol