风电叶片用单向复合材料厚度变化规律的研究与分析-纺织工程专业论文.docxVIP

风电叶片用单向复合材料厚度变化规律的研究与分析 风电叶片用单向复合材料厚度变化规律的研究与分析 PAGE PAGE VI THE RESEARCH AND ANALYSIS OF THE VARIATION OF THE THICKNESS OF WIND TURBINE BLADES UNIDIRECTIONAL COMPOSITES MATERIALS Abstract Unidirectional composites are mainly used in wind turbine blade spar caps, due to the characteristics of vacuum infusion molding process, the thickness control becomes very difficult. Currently, unidirectional glass fiber fabrics from different manufactures exhibit different characteristics in thickness. It’s necessary to study the relationship between the thickness of the layers of unidirectional composite materials in order to provide data to support the design and production of the blade, and to provide advice recommendations to the relevant glass fiber enterprises to improve production technology. This paper selects four commonly used unidirectional fiberglass fabric on the market, using vacuum infusion molding process preparation with different layers to make unidirectional composite materials, getting the relationship between the thickness and number of layers through the data fitting method. And by changing the process parameters and analysis the parameters of fabric, analyze the reasons and the impact of technology on the thickness of different fabrics in the thickness direction of the differences. In order to determine the relationship between the composite material thickness and number of layers, the paper selected two-layers, four-layers, eight-layers, sixteen-layers and thirty-two-layers fabrics, five sets of data were fitted. Fitting variance equation and the correlation coefficient with the actual production compared to determine whether the applicable fitting relationship exists. An important factor that affects the thickness of the unidirectional composite is the density of the glass fiber, and therefore it should firstly study the different fabric fiber density. This paper selects a new density test method - Indirect density test method, it is found that there