CNC数控系统廓线车削加工循环G代码的实现-研究.doc

山东科技大学硕士学位论文 摘要 ABSTRACT The current numerical control system based on the microprocessor can be realized at a very low cost, so the independent development of low cost numerical control system has a practical value. This subject discusses the automatic generation of intermediate point involved in the CNC. The main research is how to realize the ISO provisions turning circulation in the numerical control system core modules, resolving corresponding instruction explain implementation of turning G70 / G71, data processing, the algorithm and the process of the node generated. According to my own analysis, this paper gives some research of cycle node calculation algorithm related to the CNC system turning processing. The algorithm based on the object-oriented technology build up the circulation processing cutting class, where is the integration of the original data and the method of processing data, according to the original parameters，the calculation of intermediate point of stepped shaft can be relized. In the node calculation class of cutting cycle process, the algorithm solve extracting geometry information of stepped shaft from the external contour coordinates line of G70 / G71 instructions,and place it in the given data structure to program and test. According to the algorithm in the paper, the author proposes a simple simulation procedure of cutting cycle in the computer, and the experimental results demonstrate that the algorithm and procedures above proposed in the paper is effective and can automatically realize G70 or G71 automatic cycle. Keywords: numerical control system，turning circulation，stepped shaft，intermediate point，algorithm，simulation procedure 山东科技大学硕士学位论文 目录 目 录 HYPERLINK \l br01HYPERLINK \l br0 HYPERLINK \l br0绪论HYPERLINK \l br0......................................................................................................................................HYPERLINK \l br01 HYPERLINK \l br0HYPERLINK \l br0 HYPERLINK \l br0本课题研究的意义HYPE