基于MARK Ⅵ的燃气轮机控制系统应用研究-电气工程专业论文.docxVIP

江苏大学工程硕士学位论文摘 江苏大学工程硕士学位论文 摘 要 本文首先介绍了燃气轮机的控制原理及控制要求，接着介绍了当今在燃气轮机 麓 领域应用最广的美国GE公司的MARK系列微机控制的基本原理并重点介绍最新的 “ ^ MARKVI控制。 根据MARK VI控制的硬件性能和特点，针对不同型号的机组以及具体不同的情 况实现不同的硬件配置，设计采用三重冗余的硬件配置方式。 介绍GE公司的应用软件Toolbox组态软件和监控组态软件Cimplicity，并利用 这些软件实现对控制系统的保护控制和组态开发，实现对燃气轮机的保护监控功能 和数据采集功能以及友好的人机界面功能。 研究MARK VI控制系统网络通讯，根据不同的需要实施不同的网络拓扑和通讯 协议。 最后，采用MODBUS通信协议通过RS232接口实现MARK VI燃气轮机控制系 统与目标电厂联合循环DCS系统的通讯。 实际运行结果表明，本文基于MARK VI所设计的系统方案合理，运行可靠，其 投产大大提高了电厂的生产效率和运行的安全稳定性。 关键词：燃气轮机；MARK VI控制；三重冗余；Toolbox：Cimplicity；MODBUS； DCS ◆． 1◆． ^’ 江苏大学工程硕士学位论文ABSTRACT 江苏大学工程硕士学位论文 ABSTRACT Firstly,this paper introduces the control theory and control requirement of gas turbine，then the basic principal of computer control in the series of MARK is introduced． ◆、一▲ The series of MARK control Was developed by GE company in the United States，which is one of the most widest product in the gas turbine．this paper mostly introducs MARK VI in the Gas Turbine control system． According to the performances and features of the MARK VI control and the different type of units and particular circumstance，different configuration of hardware was designed．The main of the designing is Triple Modular Redundant(TMR) configuration． Introducing software of Toolbox and Cimplicity which were compiled by GE company,Using these software，function of surpervisor and control，data acquisition and human mancine interface Was developed and implemented on the gas turbine control system．． Different network communications Was designed by studying the MARK VI control system network communication，according to the different requirment network． Finally,MARK VI system imply MODBUS communication protocols over RS232 communication port，the communication is between DCS system of object combined circuit power plant and MARK VI control system． The practice result indicated that the project of this system based on Mark V1 which Was intrduced in this paper is aviable and works reliable,the use of this project in the power plant has great improv