基于光波导芯片间光互连网络设计与实现-光电信息工程专业论文.docx

华 华 中 科 技 大 学 博 士 学 位 论 文 IV IV fabrication process was simple and easy to control for the size of waveguide core, suitable for making large-size waveguides and other prominent advantages. Then, the samples of waveguide fabricated were tested and results showed the average waveguide loss was about 3dB, that would be enough to meet the communication requirements. Finally, according to the characteristics of the interchip interconnection network, we designed three different network models: fully-connected network based of bending waveguide, all-optical switch interconnection network based of optical switch array and mesh-based opto-electronic hybrid connected network. By analyzing their own characteristics, the third option was chosen. We successfully fabricated a 2×2 Mesh-based optical interconnection network for demonstrations, which included parallel optical transmitter /receiver module-VCSEL/PIN array, and realized the optical signal transmitting in waveguides embedded in PCB. Experiments confirmed that each node of this network could realized to move up, down, left, right, the light’s wavelength was 850nm, the data rate in each channel could reach above 3.125 Gbps and the bit error rate (BER) could be up to 10-16，which would be enough to satisfy communications. In a word, a new interchip waveguide-based optical interconnection network, with a conventional optical interconnection layer in printed circuit boards, was designed and realized, which could overcome the bottleneck of high-speed electrical interconnecs. It would be a innovation and could have important practical significances and applications to the development of broadband, high-speed , large-capacity information communication networks and parallel processing and transmission of high-performance computer systems. Key words: Finite difference beam propagation method (FDBPM) Optical waveguide Printed circuit board (PCB) Optical interconnect 独创性声明 本人声明所呈交的学位论文是我个人在导师指导下进行的研究工作及 取得的研究成果。尽我所知，除文中已经标明引用的内容外，本