胶印机输墨系统的性能分析与仿真研究-制浆造纸工程(印刷工程)专业论文.docxVIP

TITLE：PROPERTY TITLE：PROPERTY ANALYSIS AND STUDY ON COMPUTER SlMULATION 0F THE OFFSET仆‘KING SYSTEM Major：Printing Engineering Name：Zhongyu WANG Signature：Zl塑到选．WMSignature-社吻 Supervisor：Prof．Ganghu CHENG Abstract In this paper，the method of computer simulation was adopted in researching and analyzing the inking system of offset press．The systematic model and the simulation model were built， and the simulation experiment(to analyze the simulation results)was carried out by theory analysis．Furthermore，simulation software of inking system was developed by MATLAB。As a result，a new method is offered to design and evaluate the inking system．The main contents and innovations are as follows： (1)The relation between ink flow ratio and the plate coverage，the ink split fraction was studied by using the plate cogerage，the ink split fraction and ink split fraction as the control variable．In this study，the traditional method in ink flow ratio calculation that the plate image coverage was 100％and the ink split fraction was 0．5 was broken thron曲and reproduced the printing process more accurately．It shows that the ink flow ratio is closely relative to image coverage and ink split fraction． (2)The question of after first depth pale in media caused by the gap ofplate to do the theoretical analysis research，and proposed has used the bridge roUer solution，and has carried on the computer simulation confirmation，It shows that increased the bridge roller can solve the question of after first depth pale in media． (3)The vibration characteristics of the vibrators and its effect on the steady state of the inking system Was studied extensively，and the oscillation cyclic,stroke length and phase angle Was used as control variable．Then the ink distribution is acquired under different oscillation parameter．It provides theoretical foundation for setting the suitable oscillation parameter． (4)Has determined the wavers axial motion velocity curve throu班thetheoretical calculation and the computer si