胶印机压印滚筒挠曲变形分析及主动补偿方法研究-制浆造纸工程(印刷工程)专业论文.docxVIP

AbstmctTitle：STUDY Abstmct Title：STUDY ON DEFLECTiON OF IMPRESSIoN CYLINDER AND ACTIVE CoMPENSATIoN METHoD Major：Printing Engineering Name：Linlin LIU Signature：乜出．逝 Supervisor：Prof．Ganghu CHENG In offset，impression cylinder is critical component in transfer process of graphics context，and its flexural deformation results in unhomogeneity of printing pressure distribution．This paper studies on the impression cylinder of J2108 Offset press．With finite element method，deflection character of cylinder is achieved in static and dynamic load．Active—compensation to improve flexing．change of cylinder is bring forward，and its compensation character is simulated． The main work and results are as follows： (1)Three-dimensional model is created on the impression cylinder of J2108 offset press by Solidworks2006．The finite element analyses are employed in ALGOR V 1 8 to research the flexural deformation of cylinder in printing pressure and gravity working，deflection curves are get in axial and circumferential，and the 3D model on deflection of cylinder which indicates printing pressure is not only no-uniform in axial，but also wave—like periods in eircumferential． (2)Active—compensation to improve nexing·change of cylinder is bring forward，and flexible cylinder is designed based on impression cylinder of J2108．The simulation analysis of compensation mechanism indicates that active—compensation can effectively improve the deflection，and construction scheme is optimized． (3)Dynamic analysis is carried on in this paper，and rolling process is simulated．By transient response analysis，it is indicated that the deflection is simple harmonic vibration form in dynamic pressure，the higher the printing speed，and the larger the pressure—change．Hence the dynamic character of II 西安理工走学硕士学住论文cylioder 西安理工走学硕士学住论文 cylioder is acquired． (4)The deflection of cylinder is researched as simply supported beam with variable CROSS section．and calculating program is achieved Oll deflection of cylinder，t