金属粉末注射成形过程的计算机模拟研究与工艺参数优化-材料加工工程专业论文.docxVIP

武汉理工大学硕士学位论文Abstract 武汉理工大学硕士学位论文 Abstract The injection molding process for metal or ceram powder is a new style manufacture technology which combines plastic molding process with powder metallurgy process and powder pottery molding．It fits for manufacturing metal or ceramic parts of large batch，small，precise and those which usually has special require for their performance． This paper introduced the injection molding process．The control equation，constitutive equation and related rheologic theories of continuous mediu、m model and granule model was expounded deeply． There is a introductiOn of nuidic module of the finite element (FEM)software ANSYS which is used in this paper，and some discussion was made about the step and process in the analysis of the metal-powder injection molding which use the finite element software ANSYS． The calculation model about the runner system of the downsprue of metal-powder inj ection molding(MIM)and the finite element analysis of injection parts molding have been established．The analogue analysis of the molding process of metal-powder injection molding has been made and draw some correlative conclusion．Though the analysis of the laws of feeding material flowing in the runner of different diameter and length，find the velocity field，pressure field，temperature field of the feeding material in the runner system．Find a rational span of the length／diameter of runner from 2 to 9，and draw a conclusion that we can make a full use of existing equipment resource by modify the design of runner system．These paper provide the curve of cavity pressure倚lling time and the curve of average filling velocity of feeding fussed mass／filling time in the different injection pressure．Find the law of the influence from the injection pressure to the filling time and the cavity pressure and make certain of the best filling time，injection time and injection pressure．Though the analysis of the flowing velocity and II 武汉理工大学硕士学位论文pressure 武汉理工大学硕士学位论文 pressure