工程建设标准强制性条文CPECS-B-7房屋建筑部分.docVIP

PAGE — PAGE 100 — Chapter VII Structure appraisal and reinforcement 1. Appraisal of structure safety 1.1 General rules Reliability appraisal standard for civil construction GB 50292-1999 4.1.3 The data adopted for appraisal of safety of structure elements shall meet the following requirements: 1 Methods of inspection shall be based on the current national standards. When more than one inspecting method is to be used, a regulation for determining test value shall be agreed before the test is carried out. 3 When the detected data are doubtful for any abnormality, the judgement and treatment shall be in accordance with the current rules of the national standard; neither adoption nor abandon of data at random is allowed. 4.1.6 When performance of material of a structural element is degraded due to environmental effect and other systematic factors relating to time, it is allowed to pick up samples at random, from which 5 ~ 10 sample structural elements will be determined as inspecting targets, of which the material strength and other dynamic performances will be detected in accordance with present standard methods. Note：① When total elements are fewer than 5, all of them shall be tested one by one. Maintenance of wooden structure of ancient constructions and specification of reinforcement GB 50165-92 4.1.4 Appraisal of reliability of ancient constructions shall be divided into 4 categories according to the following rules: Category I. The existing damaged or weakened points in the structure that is load-bearing have been already treated correctly and no new damaged or weakened or sign of damaging or weakening are found. Category II. Those once damaged or weakened points in load-bearing structure have been already repaired and reinforced, yet there are individual points that have to be treated again; some newly found signs of damage or destroying that need to be further inspected and treated but do not affect safety and use of the construction. Category III.