PASABAN切纸机默乐卡速度设定作业指导书.doc

XXXX纸业集团股份有限公司 铜版纸工厂动力车间 名称 PASABAN切纸机默乐卡速度设定作业指导书 修订时间 2008－10－16 版本 01 编号 TBZWC14 页数 3 适用范围 传动完成专业 一、需用工具： 小平口螺丝刀或电笔 二、具体内容： Use a small screwdriver to move the two selectors labeled H and L, located at the top， to 0，with the power supply switched off 将电源开关关闭，用小螺丝刀将底座上标有H和L拨到0位置 Re-establish the power to the WINbloc I/O module. The default speed value or transmission ratio for the WINbloc I/O modules is 125 kBit/s and is saved in series EEPROM. This process is indicated for 5 seconds, during which the red ‘BF’ LED flashes on and off (flashing frequency: 2 Hz) 给I/O卡重新上电。以默认速度或者125kBit的速度发送参数，并且保存在EEPROM内。 这个过程大约需要5秒，在这期间，BF指示灯将自动闪烁（频率2HZ） During the 5 seconds for which the LED flashes on and off, the H selector should be set to F and the L selector left alone (I. e. set. to 0), in order to initiate the programming of the transmission speed or ration. BF指示灯自动闪烁的时候，将高位选择器调节到F上，低位选择器依旧。为了设定传送的速度 As soon as the red ‘BF’ led stops flashing, the user has 10 seconds in which to select a transmission speed value or ratio of between o and 8, in accordance with the table given below. To do this, simply move the L selector to anywhere between 0 and 8, depending on the value required. In this way, at the end of the 10 seconds interval, the module should have a value of between F0h and F8h. 当红色BF灯停止闪烁，用户有十秒钟时间从0至8之间来选择与给定值一致的传输速度值, 来做这一步, 只是将 L 选择者设为 0 和 8之间某一值，此值取决于需求值。同样，在最后10秒时间内，模块将被设定为在F0至F8之间的某个值。 Index 0 1 2 3 4 5 6 7 8 Bit rate (kBit) 1000 800 500 250 125 100 50 20 10 The ‘BF’ LED will flash (at a frequency of 1 Hz) to confirm that the transmission index has been selected. The LED will flash between 0 and 8 times, depending on the selected value. 指示灯将闪烁来确认被选择的传输速率。‘ BF 引导将会闪现 ( 在一周率 1个赫兹) 确定传动分度已经被选择。 那指示灯将会在 0 和 8 次之间闪现,根据选择的值。 The red ‘BF’ LED will flash on and off (frequency: 5 HZ) for 5 seconds in order to confirm that the programming has been completed. 指示灯将闪烁5秒来确认设定过程结束。 Once the process has been completed, the value is recorded in series EEPROM and will be