GEN2-Comfort-New电梯调试培训-电气范文.pptVIP

3.6 MRO(带有变频器运行)运行时序 * 3.7 MRO运行条件 * 3.8 ARO/MRO工地移交测试 * 4.1 变频器的几种工作状态 Internal Description Actions Init Initialization state. Indentify drive type by reading EEPROM in power section, if available. If not, use GDCB EEPROM parameter Drive Type. Power Down In this state, the power section is disconnected from the AC mains. This state is entered when the drive is first powered-on. If the AC line is valid, then the state advances to the Pre- charge state. In CAN mode, this state can also be entered when commanded to via the DrivePowerDown message to save energy (sleep mode). The drive exits PowerDown when commanded by the DrivePowerDown message Disable PWMs De-energize Safety (SX) relays Open main (MX) contactor. Open pre-charge (PX) contact. Close discharge (DX) contact. Pre- charge This is the state of the drive while the DC bus is charging. When precharge is complete, the state advances to either Wait for Safety or Idle, depending on the safety chain. If the bus does not charge in a certain amount of time, the Power Down state is re-entered. Close pre-charge (PX) contact. Open discharge (DX) contact. Close main (MX) contactor when pre-charge complete. * 4.1 变频器的几种工作状态(续1) ShutDown This state is entered after certain faults have occurred (see DECEL, ESTOP, COMP faults). The drive stays in this state until motion has stopped and 2 seconds have elapsed. The drive will NOT attempt another run until the fault condition clears. When the fault clears, the state advances to Wait for Safety or Idle .depending on the safety chain. Also, if the drive was previously commanded to Power Down, the drive will advance to PowerDown. Send stop and shutdown request (SAS) to MCSS if certain critical faults have occurred. Disable PWMs De-energize Safety (SX) relays Main contactor (MX) may be dropped for certian critical faults. Wait for Safety This state is entered when the safety chain is open. If the safety chain closes, the state will advance to Idle. Disable PWMs De-energize