c686-90中文版-矿质纤维絮垫及毡式绝热材料的分离强度的试验方法.docVIP

C 686 PAGE 343 Designation: C 686 - 90 (Reapproved 1995) ε1编号：C 686 - 90（1995年重新批准） ε1 PAGE 342 Standard Test Method forParting Strength of Mineral Fiber Batt- and Blanket-TypeInsulation This test method is under the jurisdiction of ASTM Committee C-16 on Thermal Insulation and is the direct responsibility of Subcommittee C16.32 on Mechanical Properties.Current edition approved Jan. 26, 1990. Published March 1990. Originally published as C 686 - 71 T. Last previous edition C 686 - 76 (1985).本规范由ASTM委员会C-16隔热分委会管辖，并由C16.32衬垫和松散 This test method is under the jurisdiction of ASTM Committee C-16 on Thermal Insulation and is the direct responsibility of Subcommittee C16.32 on Mechanical Properties.Current edition approved Jan. 26, 1990. Published March 1990. Originally published as C 686 - 71 T. Last previous edition C 686 - 76 (1985).本规范由ASTM委员会C-16隔热分委会管辖，并由C16.32衬垫和松散填充绝缘材料分委会直接负责。现行版本于1990年1月26日批准，并于1990年3月出版。最初版本为C686 -71 T。上一版本为C This standard is issued under the fixed designation C 686; the number immediately following the designation indicates the year of original adoption or, in the case of revision, the year of last revision. A number in parentheses indicates the year of last reapproval. A superscript epsilon (ε) indicates an editorial change since the last revision or reapproval.本标准以固定编号C 686刊发；紧随编号后的数字表示最初采用的年份，或者是修订版的最后修订年份。圆括号中的数字表示最新重新批准的年份。上标（ε）表示自上一修订版或重新批准后的编辑性修改。 ε1 Note—Safety caveat and Keywords were added in March 1995.ε1注—安全警告和关键词已于1995年添加。 1. Scope适用范围 This test method covers evaluation of strength in tension on mineral fiber batt- and blanket-type insulation products. It is useful for determining the comparative tensile properties of these products, specimens of which cannot be held by the more conventional clamp-type grips. This is a quality control method, and the results should not be used for design purposes. It is not normally used for board-type products.本实验方法涵盖了矿质纤维絮垫及毡式绝热产品的抗拉强度评估。本实验方法便于确定上述产品的相对抗张性能，上述产品试样不能通过传统的钳形夹具夹住。这