c687-96中文版-松散填充型建筑材料热阻测定的标准规范.docVIP

C 687 PAGE 356 Designation: C 687 - 96编号：C 687 - 96 PAGE 345 Standard Practice forDetermination of Thermal Resistance of Loose-Fill BuildingInsulation This practice is under the jurisdiction of ASTM Committee C-16 on Thermal Insulation and is the direct responsibility of Subcommittee C16.30 on Thermal Measurement.Current edition approved March 10, 1996. Published June 1996. Originally published as C 687 - 71. Last previous edition C 687 - 95.本规范由ASTM委员会C-16隔热分委会管辖，并由C16.30 This practice is under the jurisdiction of ASTM Committee C-16 on Thermal Insulation and is the direct responsibility of Subcommittee C16.30 on Thermal Measurement.Current edition approved March 10, 1996. Published June 1996. Originally published as C 687 - 71. Last previous edition C 687 - 95.本规范由ASTM委员会C-16隔热分委会管辖，并由C16.30衬垫和松散填充绝缘材料分委会直接负责。现行版本于1996年3月10日批准，并于1996年6月出版。 This standard is issued under the fixed designation C 687; the number immediately following the designation indicates the year of original adoption or, in the case of revision, the year of last revision. A number in parentheses indicates the year of last reapproval. A superscript epsilon (ε) indicates an editorial change since the last revision or reapproval.本标准以固定编号C 687刊发；紧随编号后的数字表示最初采用的年份，或者是修订版的最后修订年份。圆括号中的数字表示最新重新批准的年份。上标（ε）表示自上一修订版或重新批准后的编辑性修改。 1. Scope适用范围 This practice presents a laboratory guide to determine the thermal resistance of loose-fill building insulations at mean temperatures between -20 and 55℃(-4 to 131°F).本规范涉及用于确定在平均温度范围在-20和55摄氏度（-4到131华氏度）时的松散填充型建筑材料热阻的实验室指南 This practice applies to a wide variety of loose-fill thermal insulation products including fibrous glass, rock/slag wool, or cellulosic fiber materials; granular types including vermiculite and perlite; pelletized products; and any other insulation material that may be installed pneumatically or poured in place. It does not apply to products that change their character after installation either by chemical reaction or the application